CoolPoint Vortex Shedding Flow Meters

CoolPoint Vortex Shedding Flowmeters

UFM vortex shedding flowmeters are designed for coolant or water flow. They come in ¼ to 4 inch pipe sizes with a temperature transmitter option available in ¾ to 4 inch sizes. Suitable for low viscosity corrosive fluids with our 316 Stainless Steel body and Kalrez seal options. Cost a lot less than mag meters and are okay with high particulate.

Rate
Total
4-20 mA
Bright LED
2 wire with IS optional
No moving parts
Flow/temp optional
Switch or pulse optional
316 SS optional
Simple, reliable and inexpensive

CoolPoint Vortex Shedding Flowmeters

UFM vortex shedding flowmeters are designed for coolant or water flow. They come in ¼ to 4 inch pipe sizes with a temperature transmitter option available in ¾ to 4 inch sizes. Suitable for low viscosity corrosive fluids with our 316 Stainless Steel body and Kalrez seal options. Cost a lot less than mag meters and are okay with high particulate.

Rate
Total
4-20 mA
Bright LED
2 wire with IS optional
No moving parts
Flow/temp optional
Switch or pulse optional
316 SS optional
Simple, reliable and inexpensive

These flowmeter are for monitoring water add on concrete trucks. They operate in batch (total) mode or rate for continuous mix. There are no moving parts to clog or wear.

These flowmeters are offered with flow bodies of brass and Nylon end connections with PEEK sensors, Viton® seals standard and have the following characteristics and/or options:
• Engineering units (GPM, LPM)
• Max flow 50 GPM
• 1% accuracy
• Not destroyed by compressed air
• 3 digit display standard
• Pulse or 4-20 mA rate output
• Electrical Connection
• 5-Pin Male Connector (standard)